Installing .Net Framework

TransLution requires .Net Framework 3.5

In your System\SCANNER INSTALL directory you need to install three files. In order to do this, execute the NETCFv35.wm.armv4i.cab and the Message CAB files  (with the full name NETCFv35.Messages.EN.cab) by clicking each individually.

 

Installing TransLution

Browse to the System\SCANNER INSTALL

Run the translution.CAB file (may be named differently depending on the version or user preference)

After executing the TransLution.CAB file TransLution will be installed in the Program Files folder.

This file must be cut from the Program Files folder by selecting the ‘TransLution RF Scanner Setup’ folder, holding down the stylus, until more options appear, and clicking ‘Cut’. This folder should be pasted in the System folder by first accessing the ‘System’ folder, as shown on the images below.

Once in ‘System’ hold the stylus down again and select ‘Paste’.

Start TransLution by running RF Scanner as below..

To Configure TransLution for the first time you must enter the password BCR8V

Device Name must be unique to each scanner. This name must also be allocated scanner function areas in order for it to be useful. This is covered in the Scanner Permissions section of the on line help.

 

Server Name is the name of the server where the TransLution RF Server is installed. The IP address or the Host name can be used depending on the network configuration on site.

Database provider must be SQL Server.

Database Server is the name of the SQL server, where the TransLution database is installed.

Database Name is the name of the SQL database that TransLution is using.

All the rest of the settings can remain as the default setting unless otherwise specified for the site specific requirements.