Windows Mobile Scanner Hardware - Configuring Applock

By default TransLution will be installed under the scanner’s Program Files directory but the whole TransLution folder should, by now, have been moved to the System folder on the scanner. This will avoid the application being removed when the batteries run flat.

Applock is used to configure TransLution to be the only available application to the scanner operator. This prohibits the users to make changes to the scanner’s configuration that could be hazardous to the operation of the scanner device.

Click on the Start logo in the task bar.

Click on Settings

Click on the System tab

 

Click on Administration

 

Set the Application Filename to point to the TransLutionRFScanner2008.exe. This should be under System\TransLution Setup.

Enter a shortcut key and password. Recommended password is capital A

Set the Launch timeout to 90000 milliseconds

 

In general if the scanner is not responding after you have turned it off and back on again then use the attached FAQ for one of the statuses the scanner may be caught in.